1994 Kawasaki Mojave 250 Wont Start
#4
1994 Kawasaki Mojave 250 Wont Start
there are several reasons why an ATV wont start after a bath
1. water in the carb.(drain the carb bowl, and refill with fresh gas)
2 spark plug is wet, or connection between plug an boot is weak. ( take some dielectric grease and squirt it into the plug boot. then put it on thre plug.) this will keep a good contact between the plug and boot.
remember an engine needs 3 things to run: spark, compression, and proper fuel/air mix. check the spark. drain the carb and fill with fresh-unwatred gass-from the gas tank. and if it runs when dry you obviously have compression.
just good things to keep in mind
good luck!
1. water in the carb.(drain the carb bowl, and refill with fresh gas)
2 spark plug is wet, or connection between plug an boot is weak. ( take some dielectric grease and squirt it into the plug boot. then put it on thre plug.) this will keep a good contact between the plug and boot.
remember an engine needs 3 things to run: spark, compression, and proper fuel/air mix. check the spark. drain the carb and fill with fresh-unwatred gass-from the gas tank. and if it runs when dry you obviously have compression.
just good things to keep in mind
good luck!
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)