Oil removal with glide plate?
#1
I have heard that it can get real messy removing the oil with the glide plate on. I really don't want to remove the glide plate every time I change the oil, but at the same time I don't want to get oil all over the glide plate as well, even though the hole is suppose to work when doing this. Can anyone tell what they have done to get around this problem?
87 Banshee
99 banshee
87 Banshee
99 banshee
#2
What kind of Glide plate is it? DG, Baja, what? You really shouldn't have too much of a problem. Just loosen it almost allthe way before it starts leaking, and finish the last few threads with an extension/socket on the end. Be quick! You can't avoid a mess completely, even without glide plates ya still get a little sticky on the hands. Good luck.
...Freddie
...Freddie
#3
SaMs0n,
I have a DG glide plate on my Warrior & the drain hole is not even close to the oil pan plug so I tried enlarging it with a saber saw. It still was a messy job with the skid on. I finally solved the problem with a vacuum pump by Pela which vacuums the oil out thru the filler tube. It holds about a gallonof oil...no muss or fuss.I did a post on the pump a few minths ago, if you want to do a search for it.
------------------
THE AZ HARD PACKER, calmiller@kachina.net
save the public land FOR you, not FROM you..join the Blue Ribbon Coalition online @ www.sharetrails.org
I have a DG glide plate on my Warrior & the drain hole is not even close to the oil pan plug so I tried enlarging it with a saber saw. It still was a messy job with the skid on. I finally solved the problem with a vacuum pump by Pela which vacuums the oil out thru the filler tube. It holds about a gallonof oil...no muss or fuss.I did a post on the pump a few minths ago, if you want to do a search for it.
------------------
THE AZ HARD PACKER, calmiller@kachina.net
save the public land FOR you, not FROM you..join the Blue Ribbon Coalition online @ www.sharetrails.org
#4
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)