Won't idle/torn intake boot
#1
Won't idle/torn intake boot
I have a 94 sport 400L that won't idle. Used to fine, but not anymore.
I noticed a rip in the intake boot (carb to engine connects to reed cage), could this seriously affect the idling?
Before the boot was torn....
I have to have the idle screw turned all the way in for it to idle, what do i need to look for in order to correct this becuase it doesn't seem like i should have to turn it in all the way.
What does the needle clip position do? I put on a different carb(stock) and noticed the needle clip was at the top notch.
Thanks for any help or ideas
I noticed a rip in the intake boot (carb to engine connects to reed cage), could this seriously affect the idling?
Before the boot was torn....
I have to have the idle screw turned all the way in for it to idle, what do i need to look for in order to correct this becuase it doesn't seem like i should have to turn it in all the way.
What does the needle clip position do? I put on a different carb(stock) and noticed the needle clip was at the top notch.
Thanks for any help or ideas
#3
Won't idle/torn intake boot
Im picking up a new intake boot friday, hopefully that solves some of the problems.
I have tried adjusting the throttle cable a little at a time.
Ive adjusted it at the throttle assembly as well at the carb. But i gave up once it idled. (this was with the idle screw turned all the way in to start).
I have tried adjusting the throttle cable a little at a time.
Ive adjusted it at the throttle assembly as well at the carb. But i gave up once it idled. (this was with the idle screw turned all the way in to start).
#4
Quad Patrol
Don't let the hp numbers fool you. Its all in how you get it to the ground. Clutching clutching clutching!
Don't let the hp numbers fool you. Its all in how you get it to the ground. Clutching clutching clutching!
Thread
Thread Starter
Forum
Replies
Last Post
Scooter's Shop
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
23
10-22-2015 07:04 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)