I've pulled until my back hurts! I've pulled with a slide hammer, gear puller, every freakin thing I know. How in the hell do I get my rear CV joint out of the transmission on my 2000 Sportsman 500?
Oh yea, damn if I don't hate a Polaris sometimes, but I can't stand the ride of anything else!!

 

If yo look really close at where the axle goes into the tranny there is a small clip that you have to squeeze then the axle comes right out. It is recessed onto the axle with a slit about 1/2 inch. Thats where you have to squeeze it.

 

I ended up pulling the other axle out and beating it out from the other side. The CV cup shaft splines are worn, it was seized up in the transmission. Oh well more money to spend on this POS! Thanks for the help!!

 

Why do you say it is a POS?

 

the service manual says to give it quick jerk, yea right, i went through the same thing, had to do the same thing you did,if it's any consolation my buddy broke his whole rear end hosing trying to get one out of a Honda rincon. way out, out......................