My starter switch went bad, I was trying to replace it with a momentary switch i bought at napa. I can't figure out which wires in the harness need to be used except for the main power(red with black stripe) and the starter wires(white with red stripe), anybody that has any experience with this I would love the help.

 

if all your trying to do is replace just the starter switch and not the ignition, i would start at the starter solenoid a see what color wire is the *activating* wire. should be the only small gauge wire going to it. trace it back up to your handlebars and hook it up to one side of your new switch then find a hot wire that only has power when the key is on and hook it up to the other side of your switch.