Can anyone tell me the steps in replacing the clutch housing comp. The reason is that the treads on the shaft are striped off. I was abile to figure out how to take off the primary sheave and the belt ,but the secondary sheave is a bit confusing I can't figure out how to stop it from spinning so i can get the the nut off.Also I noticed a large spring behind the secondary. Is there any thing special i need to know abot that.For as the clutch housing goes it apears that a snap ring holds it on, is that correct are am I missing something?

 

be very careful of that big nut with the spring behind it. the spring is under a lot of pressure. I am not sure what exactly you are asking about so I really can't help

 

I'm trying to replace the shaft that the primary sheave sits on.I just wondering how to take every thing apart to replace the clutch housing shaft