I recently rebuilt a warrior that I purchased. It was disassembled somewhat; wiring harness was not taken off. Transmission problems required engine rebuild. Once assembled, it starts right up but will not rev up. It has something to do with the ignition; the spark is being interupted somehow. It's like a rev limiter is affecting ignition. Can anyone help with this problem?

 

check the parking brake sensor..

also.. go to the rear caliper and push the bottom of the PB in(toward the quad)

best advice is to take it off and get a block off plate..

 

I just went out to my garage and tried what you suggested and it fixed the problem!!! Thanks a lot!!!

 

welcome to the parking brake club