Raptor: Yoshi Competition FS TEC pipe, K&N, and Proflow
#21
Moose,
Yesterday I did get some seat time after the dyno jet installation(more than the usual test ride in the big field by the house) and discovered mine has a little flat spot down low also on the throttle as well. Seems like it is loading up a bit just putting around, but once you take it past maybe 1/4 to 1/3 throttle and start burning the gas, it runs like a scalded dog and pulls way through the power band. It seems a little richer than my last setup, but I'll live with it for now until I read something better, or maybe turn the airscrews in a little.
Yesterday I did get some seat time after the dyno jet installation(more than the usual test ride in the big field by the house) and discovered mine has a little flat spot down low also on the throttle as well. Seems like it is loading up a bit just putting around, but once you take it past maybe 1/4 to 1/3 throttle and start burning the gas, it runs like a scalded dog and pulls way through the power band. It seems a little richer than my last setup, but I'll live with it for now until I read something better, or maybe turn the airscrews in a little.
#22
Thread
Thread Starter
Forum
Replies
Last Post
Customer Service #1
Arctic Cat
73
05-15-2020 08:46 AM
mrtidy
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
9
02-03-2016 05:00 PM
greg86hd
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
1
09-16-2015 12:32 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)