honda 110 huge oil leak( need help)
#1
honda 110 huge oil leak( need help)
hey i had a post on here before about my honda 110 atc. i got a new head and put it on. i bought a manaual on ebay. i set the timing right. so i put it all back together and i pulled it and it started right up. but i looked down and i saw that it was pooring out oil. what do you thing it could be? i got new gasket so i think it i could of messed up the gasket where the timing chain is because so much oil came out. what do you think?
#2
honda 110 huge oil leak( need help)
I think you do not have assembled correct
There are seals that go in there other than the head gasket
This is to oil the Cam and timing chain
My bet they are not in anymore
I would not run to long
As engine only holds 3/4 qt oil but then it will stop leaking
Ray
There are seals that go in there other than the head gasket
This is to oil the Cam and timing chain
My bet they are not in anymore
I would not run to long
As engine only holds 3/4 qt oil but then it will stop leaking
Ray
#3
honda 110 huge oil leak( need help)
ok so i took it apart 3 times now and did everything by the atc 110 book and it still poors out oil. i checked the rubber gasket where the timing chain is and it looks good. so how many gaskets are there where you connect the cylinder head to the cylinder. there is the copper head gasket, the rubber one for the timing chain, is that it? am i missing one? please leave feedback. i dont know what else to do.
#5
honda 110 huge oil leak( need help)
i dont know but i made a little video so you can see what gaskets i have and to show you where its leaking. heres the link http://www.youtube.com/watch?v=3tYEOUoAtgk . i could make one of when its leaking if you wanna see?
#6
honda 110 huge oil leak( need help)
The gasket you show is in the Cam chain area
The oil to supply the cam and chain is pushed up one of the studs that hold the cyl head on
also this origionaly had a Cap nut on so not to allow oil to leak past threads
My bet is that is where oil is leaking
There is what looks like an alignment sleve but there should be an O-Ring on outside
Thanks
Ray
The oil to supply the cam and chain is pushed up one of the studs that hold the cyl head on
also this origionaly had a Cap nut on so not to allow oil to leak past threads
My bet is that is where oil is leaking
There is what looks like an alignment sleve but there should be an O-Ring on outside
Thanks
Ray
#7
honda 110 huge oil leak( need help)
that sounds like thats it. look in the picture i dont have those so it has to be that right?
<a href="http://s490.photobucket.com/al...=view¤t=110.jpg" target="_blank"><img src="http://i490.photobucket.com/al...r266/kearnsdv/110.jpg" border="0" alt="Photobucket"></a>
<a href="http://s490.photobucket.com/al...=view¤t=110.jpg" target="_blank"><img src="http://i490.photobucket.com/al...r266/kearnsdv/110.jpg" border="0" alt="Photobucket"></a>
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Hankey Pankey
Performance Mods and Project Quads
1
07-31-2015 05:50 PM
Hankey Pankey
Technical and How-To Articles
0
07-29-2015 10:57 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)