centriugal clutch install help
#1
My name is Shannon and I just pit a new one way bearing ,shoes and springs in my centrifugal clutch. I have it back on and the but is snug but I can't keep the crank from turning when I try to torque it to 87ft lbs like it calls for..how do I stop the crank from moving so I can't tighten it properly? Thank you
#2
#4
#5
I did it with a piece of pull cord ..it jammed it enough to get it tight then I hit it with the electric impact. With the pull cord it jammed it but it wasn't big enough so it would let go and not jam right up..shouldn't of bent the valves I hope at least it didn't jamm up that tight.. Nuts tight anyway ...hope for the best and lots of compression with my finger over the plug hole..thanks guys
Thread
Thread Starter
Forum
Replies
Last Post
fordfaithful21
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
9
12-07-2015 05:52 PM
cdstang
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
2
08-31-2015 07:52 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)