Belt Deflection Switch Removal?
#1
Belt Deflection Switch Removal?
I really don't need that box on top of my cover so I would like to remove it and make a polished aluminum cover. The machine will not run onless the wires are connected though. I think the new CDI will cut that switch out anyway, if I remember correctly. Can I just pull the EBC fuse in the holder?
#2
#3
Belt Deflection Switch Removal?
Yep... I removed mine ( as per PRAIRIEWRENCHE's suggestion ), but I don't have a plastic welder... I drilled out the poprivets that hold it, & riveted a thin piece of aluminum duct, on the inside, cut to fit the square, then used black silicone on the outside, to smooth over the top of the aluminum... you can't even tell it was ever there... at least when it's muddy anyways...LOL...
I'm thinking anout doing the same thing with the KBEC...
I'm thinking anout doing the same thing with the KBEC...
#4
Thread
Thread Starter
Forum
Replies
Last Post
jayking232003
Polaris
2
07-23-2015 05:48 PM
trouttracker
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
4
07-20-2015 11:54 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)