Prairie 300 mid skid plate?
#2
#4
Prairie 300 mid skid plate?
I will probably buy a full skid plate but I was just curious if they had one that fit after the A-arms and before the engine. Just a gaping hole there.
I've looked on ebay a few times but could never find anything for the 300 but found plenty for the 360. By any chance are theses built on the same frame? Would a 360 skid plate fit the 300?
I've looked at the Richochet and Armordillo ones also.
Thanks guys for the help and info
I've looked on ebay a few times but could never find anything for the 300 but found plenty for the 360. By any chance are theses built on the same frame? Would a 360 skid plate fit the 300?
I've looked at the Richochet and Armordillo ones also.
Thanks guys for the help and info
#5
Prairie 300 mid skid plate?
I have reasearched it some and what I have found is that they are not interchangable. Although, to look at the bottom of both my machines they look the same and I have not actually measured it. It may just be that the drain plug hole for oil changes are in diffrent spots. I will look at my bikes today and try to give you a better answer.
Mud
Mud
#6
Prairie 300 mid skid plate?
Much appreciated.
I looked at the 2004 360 specs and it seems the length and wheelbase are the same but the width is different. Not sure how this affects the frame though. I figure theyre not interchangeable just because when looking at the the skid plate it says its for one or the other, not both.
Guess I could always make something or just buy a new one.
Thanks
I looked at the 2004 360 specs and it seems the length and wheelbase are the same but the width is different. Not sure how this affects the frame though. I figure theyre not interchangeable just because when looking at the the skid plate it says its for one or the other, not both.
Guess I could always make something or just buy a new one.
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
ATVC Correspondent
Performance Mods and Project Quads
5
10-10-2015 10:20 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)