BIG PROBLEM!!!!!!!!!!
#11
#15
BIG PROBLEM!!!!!!!!!!
the quater size is off i may or may not put it back on depends on how well the jb weld job looks like it will hold..if i do jb it on and it comes off it wont shoot to the side i wouldnt think but either to the front or back since thats how it spins, and the clutch cover is over it as well..
ok the clutch is off and everything is ok on it except for the small chip about the size of a quater on the inner sheave, ppl that have seen it said it shouldnt be a problem! i may just JB weld the chunk back on and see how that goes.. BUT the lil peice wedged in the crank just needs to be removed. i was thinking of drilling a self tapping screw into it, then pulling the screw back out.. OR drilling it out and then to try retapping. its not in far so if thrreads are destroyed it will only be a few if any? what ya guys think
thanks
Originally posted by dczys:
thanks
#17
#19
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)