where's that make / model thread on HP?
#31
#33
I think sometimes the HP discussions are out of focused. I think CLUTCHING is a big part of how your put those extra ponies down! - IMO.
As for me I am not gauging my next one based on higher CC's I want to know how the clutching handles. - From a Big Bore operator's perspective!
Regards,
R'
As for me I am not gauging my next one based on higher CC's I want to know how the clutching handles. - From a Big Bore operator's perspective!
Regards,
R'
#34
I think sometimes the HP discussions are out of focused. I think CLUTCHING is a big part of how your put those extra ponies down! - IMO.
As for me I am not gauging my next one based on higher CC's I want to know how the clutching handles. - From a Big Bore operator's perspective!
Regards,
R'
As for me I am not gauging my next one based on higher CC's I want to know how the clutching handles. - From a Big Bore operator's perspective!
Regards,
R'
I think the factory does a fine job matching the stock clutch to a stock motor, I have to assume they know something about building the machines and mating compatable parts- it's when you start adding larger tires, lifts and extensins (and lots of operator error) that the clutch starts to fail.
#35
I think sometimes the HP discussions are out of focused. I think CLUTCHING is a big part of how your put those extra ponies down! - IMO.
As for me I am not gauging my next one based on higher CC's I want to know how the clutching handles. - From a Big Bore operator's perspective!
Regards,
R'
As for me I am not gauging my next one based on higher CC's I want to know how the clutching handles. - From a Big Bore operator's perspective!
Regards,
R'
Thread
Thread Starter
Forum
Replies
Last Post
KimSJoh
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
14
07-18-2015 08:20 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)