Min. voltage on 500 EFI's for starting?
#21
#22
Not sure what you mean about the bottom bolt but It should be self explanatory once I get into it?
#23
There is two bolts holding the starter one top and one lower, the bottom bolt will pull out abit but hit the clutch housing backplate and go no further,thats the whole reason they recommend to take the clutches and backplate off.
Its just crazy the manual does not just say,rotate the bottom bolt to the top and remove it.
Have Fun,its not a hard job.
Its just crazy the manual does not just say,rotate the bottom bolt to the top and remove it.
Have Fun,its not a hard job.
#24
#25
So how many beers does it take to pull a sp500 starter and repair it. Not sure I lost track! Good news is, I found that the starter is fine, one of the brushes was slightly corroded and sticking in a bad way. (Good call TLC) The bad! What a pain to get at, and did you know, (because it slipped my mind) if you flip the magnets on the main starter housing the motor will run the wrong way. ARGH!!! (this is where you lose track of the beer flow) At least pulling everything apart the second time was good practice.LOL
#26
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)