Rzr rims on my sportsman
#1
Rzr rims on my sportsman
I found a set of 2013 rzr 800 wheels for a great deal. I've been searching, but just cant quite figure out how they will fit.
I have a 2006 polaris sportsman 450.
My current wheels/tires are:
12x6 rim with 26x8x12 PXT tires in front.
12x8 rim with 26x11x12 PXT tires in rear.
As far as I know, the rzr wheels are 12x7, and a 4x156 bolt pattern.
Besides lugnuts and studs, does anybody know if I will end up running into any issues fitting these on my bike?
I have a 2006 polaris sportsman 450.
My current wheels/tires are:
12x6 rim with 26x8x12 PXT tires in front.
12x8 rim with 26x11x12 PXT tires in rear.
As far as I know, the rzr wheels are 12x7, and a 4x156 bolt pattern.
Besides lugnuts and studs, does anybody know if I will end up running into any issues fitting these on my bike?
#2
I put some RZR wheels on my 04 Polaris ATP had to put in longer wheel studs Polaris #7517871 [3/8 x24 x1.73]
had to get a set of new TAPERED lug nuts to mount the new rims 12mm to the 3/8 studs PUREOFFROAD.COM [ITP LUG4P]
had to grind locating lugs off original aluminum hubs to get lug nuts fully threaded threw lug nut cause newer rims centers are not machined out in back to fit outside and also had to stack 3/8 fender washer on studs to space rim out about 1/8 to fit better on hubs
A little bit of work but a different look Hope this helps
The following users liked this post:
Powerranger262 (07-08-2019)
#4
Hey Powerranger check out the back of them they might be machined out already for the 4 locating lugs for the steel rims eliminating the need for the washers and grinding. The rims I put on were used were on 12mm studs needing the use of those open taped lug nuts. The outside diameter of Std. Polaris 3/8 chrome lug nuts almost were the size of hole in rim about 5/8 not leaving much taper to bear either way think you will have to go with longer studs steel wheel lug nuts are too short. You need at least 3/8x1.50 PN#[7518378] and you use Polaris factory chrome lug nuts on them.
sorry about the confusion I needed the [7517871] 3/8 x1.73 ones cause of my shimming situation
sorry about the confusion I needed the [7517871] 3/8 x1.73 ones cause of my shimming situation
#6
#7
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)