I need help installing a teather kill switch on my kq. Bike shop said it can't be done, I think they just don't want to do it. They said too many volts up on the handlebars or something like that.

 

Did you ever figure out how to install the kill switch? If so can you help me please?

 

Why the heck would you need a tether kill switch?? Do you plan on falling off your bike a lot? Are you going to put cruise control on it? Whether or not the engine is dead when you FALL OFF probably isn't going to matter much.
The reason they put them on snowmachines and jet skis is beyond me, since I've only seen one person get a stuck throttle and then have to bail to avoid death. And it was about 30 below zero in Eureka, Alaska. AND she was an older woman.

Why don't you just install your switch as an interupter to your regular handle bar kill switch? Put it in-line.

 

I will be racing this machine. Its int he rule book I have to have one to race GNCC.

I would do that but the last EFI machine I did that too everytime you pulled the kill swtich it would bluw a fuse

 

There are lots of people riding KQs in races, you can't walk over in the pits and ask one?

 

I haven't been to a race yet. Plus I do not want to drive 3 - 10 hours get there and have to wire my kiull switch up. I rather know ahead of time

 

Did you search the Yamaha forum yet? Lots of racers there.

 

ya I have been on prally 10 sites now. I got a number for jayme who races one for cardio stack but he bought it already done.....and the only pros I know that have done it theres no way in hell they will give me there numbers...I am going to the ironman to watch I may just have to wait till then to figure it out.