Hi folks,

Can anyone give some advice on the easiest way to replace the swing-arm bushes on a Z250 please?

I think the drive shaft needs to be split to do this?

Cheers in advance folks.

 

My Z250 is "grinding" from the rear-end when I corner and I believe it is the swing-arm bushings that need replacing. Has anyone got any advice for me to change these as I believe you have to dismantle the prop shaft.

Cheers people.

 

Seeins the swingarm only moves a small amount, I'd look at the carrier bearings. Grinding in a corner leads me to suspect those.
Grab the rear tires and wiggle. See where it's moving.