Banshee running on one cylinder
#1
#3
#4
#5
Banshee running on one cylinder
if all else fails and everything works accept it running.. check the compression with a digital compression gauge (good to the .10th psi) and check your compression in both cylinders if its exactley the same or almost exactley (within a few 10ths) it could be the center seal is bad and only one cylinder will fire sometimes (happens with older sleds)
#6
Banshee running on one cylinder
Well, it turns out that it was a combination of things. First the slide in the carb was stuck. Don't know how that happened. That tripped the TORS. I started to pull the carbs off and noticed that the hose between the carbs was off as well. So I cleaned everything out with carb cleaner and it fired right up. Thanks for the suggestions.
#7
Banshee running on one cylinder
Originally posted by: Quicksand
Well, it turns out that it was a combination of things. First the slide in the carb was stuck. Don't know how that happened. That tripped the TORS. I started to pull the carbs off and noticed that the hose between the carbs was off as well. So I cleaned everything out with carb cleaner and it fired right up. Thanks for the suggestions.
Well, it turns out that it was a combination of things. First the slide in the carb was stuck. Don't know how that happened. That tripped the TORS. I started to pull the carbs off and noticed that the hose between the carbs was off as well. So I cleaned everything out with carb cleaner and it fired right up. Thanks for the suggestions.
that will do it!
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
TegraQuad
1) Engine problems..
13
11-26-2017 01:40 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)