Does anyone have any expertise on adjusting my clucth cable? I just installed new clutch plates. It now engages fine, but under load (going up a steep hill) I think it is slipping still. I just screwed the clutch cable all the way in at the lever assuming this would be the best place to start. Do I have to go back in and adjust pressure plates or what? How do I know if that the clutch discs were installed correctly?

Second the reverse will no longer engage. I wanted to get some advice on how to go about adjusting the linkage before I mess something up worse than it is.

Thanks

 

Anyone an expert in this forum?

 

idk but i need my cluthc cable adjusted also and need to know how ... i think ill make another post [img]i/expressions/face-icon-small-smile.gif[/img]

 

haywood that adjustment is for the freeplay in the lever, the actual adjustment is on the cable over the case, follow the line down and you'll see it.