my clutch on my banshee was working fine and all of a sudden it just let go i thought it was just the cable but it was we made the clutch adjustment a few times and it works but then lets go again because some how the adjustment nut keeps coming lose again so we bought i a new one but we cant get the ball that is behind it out and we dont understand whats wrong does anyone have a clue ?

 

Try using a small magnet or tip the quad on its side....

 

umm actually i tried that to its actually stuck but move when u push in the clutch it just doesnt want to come out but what do you think the problem could be with the clutch what could have broken to worn out ?

 

Hmmmm, the magnet didn't work????? Well you could try this.... Take a welding rod or a similar steel rod that will fit. take and mix up some J-B weld and put a dab on the end of the rod. Now carefully hold the rod with the J-B weld on the ball untill it sets up.. Then let it set overnight..
Next morning pull the rod out with the ball attached... This should only be done as a last resort..
Now if you do try this remember, if you put to much J-B weld on the rod you will never get it out.

 

If the rod is mushroomed on the clutch arm side you will probably have to split the case

 

shouldn't keep the ball from coming out

 

More than likely the ball is welded to the rod and the rod end is mushroomed or even welded to the clutch arm..........

 

no see if i push the clutch handle the ball and rod move then when i let go the rod goes in and i kno this because if i have a magnet attached i have to push the ball back my self so i kno its movin but i dont understand y it wont come out