Blaster Crankcase Leak???
#12
Blaster Crankcase Leak???
It is probably as easy to split the case as it is to seperate the cases and squirt a sealant in. I used a harmonic balancer puller for a car to split the cases. It just a piece of metal with slots for bolts to attach to the crankcase. with a bolt in the center to push crank.
#13
u dont need that take a shall hammer make sure all the case bolts are out thap that case softly with a hammer until u see the seam take two screw drivers and work the case apart its not hard to do and not like a honda where shims fall out all over the place all the gears etc have snap ring holding them on the shaft
#16
My blaster is having the same problem right on the bottom right side of the motor. I am fifteen and have No money to pay someone to repair it and I was wondering if I can just get a new gasket only on the right side without taking the entire motor apart?? Also is there a way to break it open without a special tool?
Thread
Thread Starter
Forum
Replies
Last Post
exmotocrosser
Polaris
10
09-13-2019 06:12 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)