right after a long ride, it was running perfect and the next day I changed the axle bearing and when I went to start it up and it made the clicking sound like the battery was dead. I charged it and it started right up. but it only lasted a day or 2. after that it made the clicking sound again and I would have to charge it again [img]i/expressions/face-icon-small-sad.gif[/img]. do I have to get a new battery?

Thanks for all replies.

 

Most likely it is the battery either that or a new starter is needed. Take your battery some where that does testing and get it tested than you'll know what you need to get.

 

When I bought the warrior in 2005 they just replaced the starter so I think I need a new battery.

 

any more suggestions would be greatly appreciated.

Thanks.

 

iv had the same problem w/ my warrior i tried replacing the battery and it worked for a few days so finally i found out it was the starter solenoid its not an very expensive part $30 at most its the little solinoid on the rear left side of the atv check it out when u start it put your finger on the solenoid if u feel it vibrating thats deff your prob

 

is that sylenmoid thing the thick wire thing that goes to the positve side of the battery. CAuse i have the same problem with the clicking and when i press the start button i feel it vibrate. any help would be apprecitraed.

steve

 

bump

 

yes the solinod would be your problem

 

Is it the thick wire or the little cylinder thing because the cylinder is what vibrates for me.