85 to 88 Suzuki LT230S Quadsport help.
Here is a brand new suzuki one for $180 w/free shipping, not too bad since that would be like $250 w/ the gasket new:
Brand New LT230s LT250s Quadsport Stator / Magneto Cover Case w/New Gasket | eBay
Brand New LT230s LT250s Quadsport Stator / Magneto Cover Case w/New Gasket | eBay
Something of note about the grab bars on these bikes. I had a PRM rear grab for mine. It didn't fit right with the DG exhaust. The corner of the grab was in the way of the muffler. It could be stressed out enough with a spacer to work but with vibration, it would probably eventually break the header pipe or the sleeve on the muffler. HOWEVER, the DG grab bar fits perfectly with the DG exhaust. Just food for thought so someone else doesn't do what I did.
Will these bearings work in the '88 lt230s a-arms?
Both Lower A Arm Bearings and Seals Kit Suzuki LT-250S LT250S 1989-1990
If so, which is considered stronger, the needle bearings or the single heim joint style bearing like this:
Upper A Arm Bearings Seals Kit Suzuki LT230S 1985-1988
Both Lower A Arm Bearings and Seals Kit Suzuki LT-250S LT250S 1989-1990
If so, which is considered stronger, the needle bearings or the single heim joint style bearing like this:
Upper A Arm Bearings Seals Kit Suzuki LT230S 1985-1988